Thanks Brion Great WIP!

Brion, I too look forward to seeing this project to completion. If I may ask,what was the dimensions of the 1084 and the 15N20 when you started the bi...

Gary; Your snow flakes may have not turned out like you envisioned, but it still is a neat pattern. I'm sure you learned from this project! ...

Thanks Larry for posting! A great video. Every move counted, no wasted energy. Russell

Gary, are you using the press for all your welding, and shaping or do you use a power hammer and the press? I haven't done a pattern that complex. I...

Great WIP! Gary, I'm looking forward to the results! Russell

Brion, Do you know what temperature your forge was running? I'm going to try this on my next billet and record temp and soak time at welding heat....

Kyle, Thanks for your post! It was what I wanted to here. My setup is going to require more than one cutter and in stages. With your advice, I ...

Thanks, Javan for your reply. I realize there are a lot of variables in doing this pattern. I was looking for a starting point. I have a wedge almost ...

Hello Trent Trent look at the bottom of the wiring diagram to see if there is the option to change rotation, most motors have this option. It w...

Congratulations! on what sounds like a very successful hammer-in. I salute you and your team for making it a success. The picture of Lin and the...

Congratulation Bill! The news is published fast here at the ABS web site! Thanks to Lin and Dan! Russell

Hello Ed, It is good to hear you are back in the shop! Wow! What a demo. They don't get any better than that! Thanks for sharing! ...

Congratulations Zack! Russell