If all goes well, we are going to deposit in my shop Friday. I jumped on it like a bream on a cricket! See you at the hammer in. Bob
Welcome Darrell, You live in one of my favorite areas. Visited Cody 5 years ago, and didn't want to leave! Nice website, too! Go...
Joseph, We learned in Intro Class that blades can warp no matter what type of quenchent is used. That is why it is important to follow the pro...
Welcome Ed, I know you are going to learn a lot, because I have. Good luck on your journey! Best, Bob
The 2x72 grinder with variable speed, drill press big enough to mill or vertical mill that will also drill. How about a gas mig welder and oxy/acet t...
Hi Sean! Welcome aboard! What part of Mississippi do you live in? I'm just outside of Hernando in DeSoto County. Bob
A video on how to use a disc grinder would be helpful. I read about how helpful they are, but I have never seen one in use. Thanks! Bob
Nice work Jeremy! Looking forward to seeing the finished knife. Bob
Welcome to the ABS Teddy! Bob
Gary, Great tip! I'll have to give it a try. Does it match up good when using nickle silver? Thanks for sharing! Bob
Logan, Welcome! I attended the Intro Class back in April. Not only was it fun, but it really cuts the learning curve. I highly recommend...
Jared, I ordered them from Enco. They are on page 234 of the online catalog. Like I said I primarily use the 1/8" cylindrical, double cut. I h...
Jared, I read your post over in the video suggestions about the crooked hole. What I did was practice on a piece of 2x4 that I drilled like my ...
Joseph, I would recommend purchasing the book, Handles and Guards, by MS, Joe Keeslar. It goes into step by step detail (with illustrations) on ...