It was a really good one this year! An hour or so of light rain then it turned into perfect weather to be outside. Lots of tools and materials for...

The Hammer-In is NEXT weekend. B.R. Hughes has set up a great set of demos. All of you who are going for a stamp in ATL or KC this is a great opp...

Wes; I haven't drilled jade but I did do a handle in quartz and in granite. I used a 3.5 mm non core drill. I ran at very high speed, low pressure...

At the risk of repeating myself; this is one not to miss. With the Harveys there you can see some demonstrations that are just not avail here in the s...

I say go for it if you can make it work; frame handles are nice. Just remember; your fit up, alignment, and finish will be the criteria on which yo...

Don't worry over two in/ three out on the VFD. The little yahootie in the box pushes all the right buttons. Three phase motors need three lines and...

Become obsessive about flat, parallel, and perpendicular. A micrometer will teach you very much about your grinding. Guard material must be flat, pret...

I will help you if I can. Please private msg. or call if I can be of service. Mike

It's not long till fall weather!! The Fall Piney Woods should be a blast this year. Old friends Kevin and Heather Harvey will be sharing t...

Mark; Not trying to sound too gruff; but the judges won't care whether it's your fathers phone board or came from Thomas Edison himself. They will...

Very nice work!!!

"isolated" is South Africa, or Brazil, or Belgium, or Australia, or Canada . My first hammer-in all my money went for gas to get there and back. Sleep...

Holes too big=drill error, machine error, operator error or combination of all three. If the holes are sloppy in your bolster they are probably slo...