Michael Sargent
Member
Joined: Feb 15, 2021
Topics: 0 / Replies: 7
Reply
Heat Treat Oven

[quote name='Jason Volkert' date='19 January 2019 - 06:46 PM' timestamp='1547948797' post='23865'] Thanks for the info Gary. I'm going to go with th...

6 years ago
Reply
1084 And 80Crv2 Forge Welded

While I have not tried 80crv2 and 1084, I have done 80crv2 and 15n20 and it worked just fine. I basically tried it just to see if the two would stick...

8 years ago
Reply
Save The Paper Try A Diamond File

I have been looking for something better than paper. I have tried mold stones, but being so small, they are hard to use. These look like they would ...

8 years ago
Reply
Damascus By Hand

I took the advice of a couple of the smiths on here, namely J.d. Smith and Matthew Parkinson, and did my first damascus billet dry and by hand. For m...

8 years ago
Reply
Damascus Pattern Development - Topic For July 2016

This topic is near to my heart. While I may be getting ahead of myself, damascus/pattern welded steel has captured my attention. I look forward to t...

8 years ago
Reply
Thank You!

Thank you guys for taking the time to moderate these forums and to share your knowledge and experience. As a new smith, it is immensely helpful.

8 years ago
Reply
Anatomy Of A Forge Weld – Topic For June 2016

Just to bring some more discussion to the table without adding anything to it personally, what about the anatomy of a forge weld with flux vs. the an...

8 years ago