It's good to see guys who work toward their goals with deliberation and determination. I hope we can witness it. Thanks for inviting us along. Let us ...

Greg, Making a knife in two weeks is quite different than LEARNING to make a knife in two weeks. I would like to give you an example of one o...

I appreciate you taking the time and effort to do this WIP Gary. It's a great job you've done.

Nicholas, The guys have told you correctly. To leave marks on the face of a guard or bolster is not acceptable in the context of the test...

Personalizer Plus. I still stamp a few but this is much more consistent. I burn it deep enough that it looks like a stamped logo. I use a clean ...

I look forward to seeing it Gary.

I love the video Karl. Great example of fit up and the explanation of your reasons for doing things is very helpful. Great knife.

Good job Gary! I can attest to your words! It will force you to study the smallest details in line and flow. You will invent ways to get it do...

Yes Joshua, that’s right. Thank you!

Here's a picture that I enlarged and marked to show the joint. The joint is under slight pressure from the rear attachment. It pushes forward...

Thank you Brion. As you seen in the photo of the forged guard, it's in one long piece. At some point I realized that the section just below the h...

Thanks guys. Jesse, feel free to make anything you want. The first thing I did was drill a small hole in the center of that cylinder. I the...

Here I've laid out the shell and started the steps. I notched the edge and used the notches as starting points for the filed grooves. They aim toward ...

Jesse, Do you mean the thin spacer with notches? It's a piece of stainless that I coined the edges with a checkering file. After that I filed a bevel ...