Kyle Royer
Kyle Royer
Master Bladesmith
Eminent Member
Joined: Feb 15, 2021
Last seen: Dec 6, 2023
Topics: 2 / Replies: 30
Reply
2014 Heartland Bladesmithing Symposium

Hey guys! Caleb Royer here. Interested in knife photography? I’ll be demonstrating how to quickly shoot high quality knife photos without spe...

10 years ago
Reply
2014 Heartland Bladesmithing Symposium

Hey everyone! I'm looking forward to this quite a bit. My demo on complex damascus will be pointed towards mosaic damascus. I'll be talking...

10 years ago
Reply
Global Warming?

-13 here in Southern Missouri early yesterday morning! I'm pretty sure we're getting some record breaking or nearly record breaking temperatures.

11 years ago
Reply
Usa - Total Ivory Ban Proposal

We need to get everyone we can to send the attachment in Larry Fuegen's post as quickly as possible.

11 years ago
Topic
Replies: 31
Views: 753675
Reply
Belt Grinder Tracking Wheel "smoothed" Over

I've been able to re-crown the wheels on my grinder by ripping a 2x72 sanding belt into a 3/4 wide by 72" sanding belt and then run the grinder with t...

11 years ago
Reply
Best Type Of Forge For Welding?

I'm using an old shopvac that has a "blowing" air port on it. I have a valve on my air duct so I can regulate how much air the forge gets. I have al...

11 years ago
Reply
Eugene Loro Shop Equipment For Sale

Thanks Mrs. Sheely, With your help I was able to get in contact with Jim Loro. Thanks again for helping me out.

11 years ago
Reply
Eugene Loro Shop Equipment For Sale

I too sent an e-mail on the 12th with no reply. I sent it to Jim Loro asking about some of the large equipment on the list.

11 years ago
Reply
Wedge For Making Feather Damascus

I cut my feather in three to five heats. But even if one wanted to cut it all the way through with one heat it could be done by making the consecutiv...

11 years ago
Reply
Wedge For Making Feather Damascus

An 1/8 inch radius on the end of my feathering cutter is what I use. You can make a knife of nearly any reasonable (i.e. 15 inches or shorter) length...

11 years ago
Reply
Copper And Brass Patina/oxide, How To Avoid?

I get my silicon bronze here, you have to purchase six foot long pieces at a time if I remember correctly so I've only ordered once and have been usin...

11 years ago
Reply
Forge Info

Here's where I get my forge supplies. If you're going to be making a lot of damascus I recommend a forced air forge. I built mine after scavenging p...

11 years ago
Reply
Video Suggestions For Abs Youtube Channel - Topic For July 2013

I love seeing WIP videos on just about everything and anything. So more of those are always good. I like the ones that fallow one knife build and th...

11 years ago
Reply
Decorative Filework Techniques- Topic For June 2013

Microscope, high speed dental burr and three sided file with one safe side is what I use for all my filework on thin liners, i.e. 0.064 to 0.020 I lov...

11 years ago
Page 1 / 3