Yep - just make a cover for it. [quote name='Javan Dempsey' date='06 March 2013 - 06:25 PM' timestamp='1362615903' post='6734'] Great video ...

Javan - here ya' go: [media][/media]

Nice process, Mike. I know there are other methods that folks could share if they'd only take a minute. I came across a photo I had of three knive...

I like to do a pretty deep etch. I use 3:1 ratio of distilled water an FeCl. I normally etch 15 minutes, four times, cleaning off the oxides betwe...

The tracking adjustment is around the back side of the the tracking wheel at the top. The arm is long because the belts are 6 feet long. It's sol...

I used the tooling arm from a Grizzly grinder. Had the wheel cnc machined using a 95 durometer rubber coating on a hub that was perfectly matched to...

I think there's a LOT!! of people holdin' out on us.

Well I am certainly looking forward to my first table in Little Rock. Not only will I be able to meet some new customers, but it's a chance to mingl...

Phil, I bet you get good mileage on that!

And then we have - "Mr. Twister"!

This will give an idea of how I like my forges on wheels. Of course, I have now moved to a new location and these are old pictures, but I now also h...

Actually, those are not bluing tanks. I welded those up out of 5/32" steel plate which is heavier than the bluing tanks. These do hold about 5.6 ...

Here are a couple gadgets I use in the shop regularly. First is my "Damascus Horse" that I use for welding and grinding billets during the pattern w...

Here's one I have not use for a year or so, but should put back into use one of these days! It is very handy for those wanting to do some wire i...

Fantastic hamon and a great knife overall. Quite inspirational.