Exactly Karl. The trick to knowing what will happen is to extend your imagination and picture the pattern in your head as it becomes stretched and elo...
Evan, A serrated wheel cuts much faster than a smooth one. For rough grinding stages, I use a 8" serrated wheel to chamfer the edge, set the plunge ...
Go for it. What have you got to loose? You say "I like the look but am wondering what would happen if I cut, stack, weld and twist again?" Well, there...
I also donated a knife I made up for sale and two Damascus blades. The blades have been sold. The knife (pictured below) is on the Facebook website. (...
Matthew, it sounds like a plan to me, but be careful with that heater. I'm not familiar with turkey fryers and the temp settings, but you typically wa...
I'm with Karl and Shawn on this (with minor additions). Karl for using the Tim Hancock method. If you want to learn flat grinding, and can buy Hanco...
[quote name='Ed Clarke' date='31 December 2015 - 09:32 AM' timestamp='1451579548' post='15569'] Hey Guys, Anyone have any more info on the spec...
That's a very nice looking knife Chris. I don't think the guard is too thick. You could have thinned the lower tab a bit more, but that's a purely sty...
Knife making and rock climbing.......two of my favorite pastimes. Nice looking knives too.
Whatever epoxy you use, and Karl has suggested what industry standards are often considered the "best", leave your mixing palette and spatula on the w...
Evan, to answer the question: Joshua, with the ball valve between the shut-off and the needle valve, does that mean you run the needle valve wide op...
I'm with Karl on this one. I built a very similar rig after using venturi style burners for a long time. It can be a little tricky getting the gas/air...
Warning: I like to answer questions with another question...... What size stock are you starting with? Do you have a drawing of the finished knife? ...
OK, I found it. Luckily enough my wife has taken the initiative and collected all of the Hardy tools we have and put them in one place. Unluckily thou...