[quote name='Joshua States' date='17 June 2016 - 07:54 AM' timestamp='1466175258' post='17338'] I change the paper on the disc. By the time I'm done...

[quote name='Lin Rhea' date='07 March 2018 - 10:21 AM' timestamp='1520443269' post='22193'] I fit my guards pretty well as Brion and Ed has describe...

Funny this topic is up here now. I also tight fit my guards with the back side cut out enough to file the shoulders on angle for tight fit. I then fit...

Welcome to the ABS Rob. Jim

Welcome to the ABS Fry brothers

Yes it was you Steve that stepped up to the plate on very short notice. Thanks again. We have had the privilege to have some great makers demo in the ...

[quote name='paul savage' date='27 November 2012 - 04:33 PM' timestamp='1354059209' post='5812'] Sounds like a great time Jim. To bad I'm in ontario...

Here is a picture of my Hydraulic rolling mill which is attached to my hydraulic press. Both units run off the same power unit. (hope Ron doesnt min...

[quote name='Jonathan Stanley' date='18 November 2012 - 11:27 AM' timestamp='1353263267' post='5665'] Hey Mr. Jim, Is that damascus? Sorry but wh...

[quote name='Andrew Telfer' date='10 November 2012 - 07:15 AM' timestamp='1352556930' post='5589'] Thanks for your comments. I live about 10 minutes...

heres the pics Attached files

here are a few pics of the handles and guards class