Jason Fry
Apprentice Bladesmith
Estimable Member
Joined: Feb 15, 2021
Last seen: Jan 7, 2024
Topics: 36 / Replies: 90
Topic
Replies: 3
Views: 1463
Reply
Takedown Nut Options

I've used the female side of a corby bolt before. My particular one wasn't a true takedown, as I ground the head down flush after final assembly, but...

7 years ago
Reply
Curiosity: Do You Use Masking Tape In Your Shop?

I shoot the blade with Wd 40 then use the blue tape on top of that. It doesn't stick well, but it keeps the rust down. I haven't had issues with ele...

7 years ago
Reply
Howdy From Texas!

[quote name='Daniel Macina' date='02 November 2017 - 09:06 PM' timestamp='1509678405' post='21428'] Thanks guys! Actually I'm from Colorado...

7 years ago
Topic
Replies: 4
Views: 486
Reply
New Guy In Tx Hill Country

While we're not affiliated with the ABS, you should also check out the Texas Knifemakers' Guild. We do knifemaking events around the state, and many ...

7 years ago
Reply
Grinding Belts

I'll start by saying that I do grind quite a bit of hardened stainless, so your mileage may vary. I start with a 50 or 60 grit 3m 967 running abo...

7 years ago
Reply
Etch-O-Matic

I've had much better luck with professional stencils. TusTech is my current go-to, but IMG and Ernie Grospitch are both well spoken of. There's a gu...

8 years ago
Reply
Treadle Hammer

So two years later, having moved and had twin boys since I was gifted this hammer, I finally today got it set up to do work. I built some dies out of...

8 years ago
Reply
W2 And Sheep Horn

Thanks for the resize, Karl!

8 years ago
Reply
Answers To Membership Questions

Is there a PayPal option for paying dues?

8 years ago
Reply
W2 And Sheep Horn

Here's the pic Caleb Royer shot for me of this knife. Nevermind, pic was too big. Link instead.

8 years ago
Reply
W2 And Sheep Horn

[quote name='BrionTomberlin' date='26 October 2016 - 09:47 PM' timestamp='1477540024' post='18538'] Good looking knife Jason. The browned fittings a...

8 years ago
Reply
Hidden Tang Or Mortised Tang Handles -Topic For November 2016

Where are you guys finding these super long endmills? I'm thinking you'd need a 3/16 by 3" at least?

8 years ago
Page 4 / 9