Welcome. Really nice work. Where are you in OK?

I did that at first too. It worked fine but I was concerned with the strain placed on the motor; dont know if its justified, but I didn't want to bur...

I am new to the blown forge setup. I just recently added a blower; so I'm still tweaking mine as well. My only comment is that those bounce house bl...

[quote name='Mitchell Rokicki' date='06 August 2010 - 04:06 PM' timestamp='1281132382' post='642'] Jarrett, How'd you make out with the Tulco oils? ...

[quote name='Mitchell Rokicki' date='06 August 2010 - 04:06 PM' timestamp='1281132382' post='642'] Jarrett, How'd you make out with the Tulco oils? ...

The link below will take you to a post I made on the Bladesmith forum recently. For full disclosure, I've not yet tested the oil I purchased so I can...

I painted my grinder and other equpment with a good grey rust inhibiting primer. This works great and I prefer it to a gloss finish. They get covere...

To start I am not a welder but can weld. I own a Hobart Handler 140. Runs off of 120, came with a gas guage set up and has a pretty good duty cycle;...