I would assume the blueing and a micrometer to scratch on each edge of the face has been done? So each face of the Octagonal would be .383 and then ...

Well I am trying to get motivated to go out to my shop and do some online streams of my process. Sure its raw footage but I only have the one camera o...

if only there was a place to post the newsletter or a link to it... wink wink, nudge nudge

I didnt see a newsletter. snifff. tear sure sounds like it would be a nice read... que music all by, myselllllelelllf

Exciting! I need to build a bigger one as well. Yours looks great! Do you have concerns about the screws rusting through the refractory ce...

My first benches were 2x4 and 4x4 depending on the weight needed. But I went to local steel shops like the local welders and fabricators and asked if ...

Thanks to all three of you, I appreciate your time in replying and apologize for the delay in my response. I will see what I can do for putting m...

Nicely done WIP and finish product. those contrast lines are pretty nice!

I would think you could do a cut out section in leather. then when you epoxy them together and clamp, it will fill in the voids of the wood imperfecti...

Super good advice, thank you. Ill hope to post an update this weekend. Thanks Joshua.

Well also looking for peening advice on something like this. I have not tried it. I just know to use a thousand lighter taps rather than 5 heavy one...

Awesome job to you all!

Great shop! I am still doing the corner of garage thing, but some day the Brinks truck will back up into my drive with alll my lotto dollars and...