Dennis Clark
Apprentice Bladesmith
Eminent Member
Joined: Feb 15, 2021
Last seen: Nov 10, 2024
Topics: 7 / Replies: 23
Reply
Pommel Plate

Lin, Steve, I got the pommel plate started today and it really looks nice. I used your advise and got it fitting perfectly. Thanks for the help. I ...

14 years ago
Reply
Pommel Plate

Thanks for the response Steve. That's a great tip about using the pencil lead to check for high spots on the antler. I was worried about pins holdin...

14 years ago
Reply
Pommel Plate

Thanks Lin and yes, it is curved. I added another photo. Any suggestions on how to pin the plate to the handle? I was going to just use brass pins....

14 years ago
Topic
14 years ago
Replies: 8
Views: 3639
Reply
Induction Heating

Great info guys and thanks. I would like to play with one but I'm gonna stick to my forge and heat treat oven.

14 years ago
Reply
Induction Heating

As usual, a great reply Kevin. After continually reading I found out as you said, it will definitely heat over non magnetic and will even melt the me...

14 years ago
Topic
14 years ago
Replies: 5
Views: 3622
Reply
Tank Size For Quench Oil

Thanks for the photos Karl, I can see how it would be much easier to keep the horizontal tank clean. I'll start working on a new tank tomorrow.

14 years ago
Reply
Tank Size For Quench Oil

Thanks Kevin. Sounds like I need to double my tank size. I will try a 10 to 12" vertical with at least five gallons of Parks.

14 years ago
Topic
Replies: 13
Views: 11145
Reply
Radius Platen

Thanks for the reply Dan. So I take it that this type of grind would work well on a large camp knife, or even a JS test knife? Don't get me wrong, I...

14 years ago
Topic
14 years ago
Replies: 4
Views: 4337
Reply
Wuertz Tw90 Grinder

Thanks everyone. I also heard from Josh Smith who just obtained one. He had it next to his KMG in a side by side test. Thanks for the input, I've f...

14 years ago
Topic
Replies: 3
Views: 10152
Reply
Emploring You To Take Care Of Yourself When Working In Your Shop!

Ed, do you have any recommendation on the appropriate filter to use with the 3M 7503?

15 years ago
Page 2 / 2