Last seen: May 12, 2021
Welcome. Any questions? Just ask. Someone will have an answer. As to books and videos. Get them all. You'll never have enough. Dale
Welcome David. In your spare time, go back and read some of the old post. There is already a world of information on this forum. You just have to hunt...
I use a burner I use is almost identical to Steve's. The main exceptions are a needle valve, to regulate the gas flow, in addition to the ball valve t...
I agree with all the above. Also, the quest for the J.S. certificate, and hopefully the M.S. certificate eventually, has made me a better knife maker....
Welcome aboard. Dale
Welcome! Dale
Welcome! Dale
You can use a strong solution of baking soda and water. Dale
I normally get mine at Radio Shack but will probably get it from ebay next time. Sierra Chemical has it there for $39.99 a gallon. Dale
Outstanding Steve! Dale
Welcome to the ABS Dale
I stamp my forged blades and etch my stock removal blades. Dale
Very nice. I like it. Dale
Kyle, my set up is pretty much the same as Steve's. The only difference is a needle valve between the ball valve and the nipple and a ball valve to re...