Dale Huckabee
Dale Huckabee
Member
Joined: May 31, 2010
Last seen: May 12, 2021
Topics: 12 / Replies: 205
Reply
Source For Anvils?

Does your state have a farmers association? If so they probably publish a magazine. I see anvils for sale in my state's farm bureau magazine every now...

13 years ago
Reply
What Makes A Knife Look Good

I agree with Lin, that's a hard question to answer. Like everything else, beauty is in the eye of the beholder. Expensive materials, engraving, filewo...

13 years ago
Reply
Ats34

I don't know about using salt pots, but I have always used Paul Bos to heat treat any ATS34 that I've used. Sorry, I don't have his address handy. ...

13 years ago
Reply
Gas Forge Burner Construction Advice

I'm using an 80 cu. ft. blower that I got from Surplur Center which is more than enough. I use a gate valve to control the amount of air going to the ...

13 years ago
Reply
Any Book Or Video Recommendations?

I almost forgot about Joe's book and it's laying on my work bench right now. It should be right at the top of the list Dale

13 years ago
Reply
Any Book Or Video Recommendations?

I have so many it's hard to know which to recommend. I have probably watched Bill Moran's videos the most. As to books, I would say that I go to Blade...

13 years ago
Reply
Pyrometer

That sounds great Steve. I don't use mine a lot, but it comes in handy for heat treating. With a little tweaking I can regulate my forge to whatever t...

13 years ago
Reply
Pyrometer

I ordered my K-type probe from Omega. I called and told the rep what I was going to use it for and that I needed it to be able to withstand up to at l...

13 years ago
Reply
Gas Forge Burner Construction Advice

Hi Jon, Check out this site www.dfoggknives.com/forge.htm. I've built several forges and burners using this design. All have reached welding temp...

13 years ago
Reply
Richland Creek Hunter

I have to agree with the rest of the guys as to how the hanle "Looks". That being said, I've know some guys that complain about most knife handles bei...

13 years ago
Reply
Pattern Welded Hunter

That looks much better. The only thing I can see wrong with it is that your handle, at the back of the guard, should match the width of your blade (re...

13 years ago
Reply
Ideas For Hammer-Ins

Hi Dan, I for one would love to see demos on mills and lathes. Dale

13 years ago
Reply
Passing Of Greg Neely's Father

Sorry to hear of Greg's loss. My thoughts and prayers go out to him and his fanily. Dale

13 years ago
Reply
Some Knives I've Done

Justin, handles and guards are a challenge for me also. I've often said that I wish I could just forge the blades and let someone else do the rest. Yo...

13 years ago
Reply
Grinding Belts-Time Savers?

This is a topic that I will be following closely. I know it's not a good practice, but I have a bad habit of trying to use a belt way too long. Someti...

13 years ago
Page 12 / 15