Yes that is what I use. It works well for places that are hard to get to and is a little faster than sand paper. Try it in 400 and 800 grit. 1/8...

PDF file of the pattern we are using, the handle on this one is 3 5/8. Pattern.pdf

3/32 drill bit, .003 shim stock or a feeler gage blade, 3/32 pin stock. Blade and spring steel, liner material and bolster material. 410 liners and 41...

Some of the small tools I will use; #1 is a file guide mine has carbide faces. Make sure you have a good one without a bunch of slack. ...

Yes I will Rick.

You can make something like this to attach to the arm on your Bader. Or you can modify a spare flat platen like this, ...

The post office said the patterns will be there on Saturday..... So go stand by the mail box. Craig

Sounds good. I think everyone working with what they have will be the best. We have enough makers on the forum to work out any snags or problems that ...

I have the patterns finished and will get them in the mail today or tomorrow. I will be using 3/32 stock for this knife most likely CPM-154 but any go...

Looks like five for now, I will make up some patterns to send out. E-mail me with an address and I will get them in the mail next week.

4 1/4 closed 4 1/8 closed This one is 3 5/8 3 7/8 and 4 1/8 closed 3 3/4 closed

Good idea Phil. Any of these two blade knives can be made as a single blade. This one is 3 5/8 closed This one can be 3 5/8, 3 7/8 ...

Joshua, after ICCE I will put something together on making the plate and using it to mill the liners. It is not that difficult just taping a lot of ho...

We are getting close.