Steve that turned out beautiful! What a treat to see this finished with so much detail to look at from every angle. That is quite an impressive ...

Peter Wright anvils are good anvils, but old and often abused. "OK condition" does not sound like one I would want. A 167 lb in Good condition would...

I had to look it up too I would tend to use it as designed as he has already done a lot of research. Another thing to remember if you g...

Evan. It does sound like your edge did not have enough support like you said. I would also agree that you are holding the blade too flat on the bel...

Jared I would suggest placing a couple of bags of concrete around the anvil post and see if that dampens the motion. If it does, you could frame...

It is looking good so far. I will be interested in seeing your crank assembly. As I am looking at this, I wonder if the Hawkeye setup with the linka...

Jared On the hawkeye hammer, I scaled out the arm with the assumption that the wood beams are 6x6. The arm is 32" long, so I would say that you ...

Jared Take a look at this hammer below. It is a rebuild of one that was manufacured long ago. The concept is pretty straight forward and this is...

While this is a great knife, the story that goes along with this makes this piece really special. With the piece created, destroyed, and created agai...

I agree with Lin Thank you so much Dan and Sally for all you do. It is much appreciated! Brian

John I think that your questions have been answered pretty well here. The one thing to remember is what this organization is about. I enco...

I would like to thank everyone whose knives are displayed here. The knives are fantastic and your contributions are much appreciated. Thank you ...

Landon I use tie wire -- like that used to tie rebar together for concrete work. This can be purchased at just about any hardware store or Lowes...

Russell Soem additional info What kind of surface grinder do you have? If you have a Brown and Sharpe 2B, I can give you the wheel dimensio...

Russell See this link. grizzly grinder parts You need Part 36A and everything above it less the platen. The Grizzly grinder part 36A mounts to ...