Last seen: Dec 28, 2023
Congratulations Ben!
[quote name='Karl B. Andersen' date='03 September 2012 - 07:08 AM' timestamp='1346674110' post='5170'] When it comes to respirators, there can be on...
I have always had fun at the show and look forward to seeing everyone in just a few weeks!
Way to go Ben! Wish I could have been there.
I have taken the Handles and Guards class with Joe Keeslar and enjoyed it. First be sure have your two blades completely finished. When I went half th...
Thanks for taking the time to photograph and post your dies! I am sure that I will not be the only one to find it helpful.
Anyone use the little giant die system where the dies are bolted into a dovetail for quick die swapping?
Zach, what kind of trip hammer are you getting? Karl, I was just watching some of your videos last night squinting and trying to see what dies y...
Here are the motor plates:
It would be nice to have dirty and clean areas. If you can isolate your grinders etc. you won't have to deal with the dust as much where you are hand ...
Congratulations! I will have to set the TIVO once it hits the air.
How about $600 each.
I've got a copy and it is quite full of eye candy!