Notifications
Clear all

Where Can I Find Some Extra Long End Mills

4 Posts
3 Users
0 Reactions
3,752 Views
Posts: 177
Reputable Member Journeyman Bladesmith (5yr)
Topic starter
 

Hello,

I've seen 3/16 end mills up to 6 inches before. I found them at 4 inches on a website that I just can't find anymore. Usually extra long for these is 3 inches. I'm going to be using it on wood, and I don't mind going slow, but I know that length is not a typical size.

Any help would be much appreciated.

Thanks,

Nick

 
Posted : 10/11/2016 1:48 am
Ed Caffrey
Posts: 751
Prominent Member Master Bladesmith
 

My recommendation is to search Ebay. Most of the time when I'm looking for something that I know is a hard to find item, I go straight to Ebay, and if I can't find it there.....I know it's gona be tough to come by. The "trick" that I've learned with ebay is to go there everyday and search for the item(s).....sometimes it takes weeks of doing that, but historically, sooner or later I find what I'm looking for. Of course in the mean time I'm searching the web. Whether it be ebay or the web in general, trying different specific words within the search dialogue makes a world of difference.

In your case I'd start with "6" endmills", or " 6 inch endmills". Then start widening with terms such as "extra long end mills" "long reach endmills", etc.

Ed Caffrey, ABS MS
"The Montana Bladesmith"
www.CaffreyKnives.net

 
Posted : 10/11/2016 1:34 pm
Posts: 177
Reputable Member Journeyman Bladesmith (5yr)
Topic starter
 

Thanks Ed!

I found a site that has 4 inch 3/16th endmills. I thought I'd pass along the info if anyone else is looking. I'm hoping to make my hidden tang life a little easier.

http://www.allindustrial.com

 
Posted : 10/11/2016 8:28 pm
Posts: 40
Member
 

Here is another online source

http://www.lakeshorecarbide.com/4flutelongendmillscoatedanduncoated.aspx

 
Posted : 11/11/2016 8:45 am
Share: