Video - Using a Magnetic Chuck by Master Smith Hanford Miller
Master Smith Hanford Miller demonstrates the use of a magnetic chuck for machining tasks on knife components in this ABS YouTube Channel video. This is the profile page for Hanford, Click: Hanford Miller.
[media] http://www.youtube.c...h?v=6jaZ7RPknO0 [/media]
Dan Cassidy
Journeyman Smith
Send an email to Dan
Very good idea. Where can one find a gizmo like that?
Bob
Bob
Enco, Grizzly, Harbor Freight are a few places that you can find them. E Bay is another place. I am not sure about the $50 that was mnetioned. They are usually much more expensive than that.
Brian
Thanks for the information Brian, I'm getting an order up for Enco, so I'll check their's out.
Bob
