Notifications
Clear all

Grinder Wip

10 Posts
5 Users
0 Reactions
596 Views
Posts: 36
Member
Topic starter
 

Well I'm starting a grinder build and figured I would do my best to take pictures as I go. It will hopefully be very similar to the KMG design.

Attached files

 
Posted : 29/10/2018 6:27 pm
cal harkins
Posts: 69
Member
 

I look foward to seeing your WIP

 
Posted : 29/10/2018 7:52 pm
Lin Rhea
Posts: 1563
Member
 

Daniel, Your photos need resizing a bit smaller please.

Lin Rhea, ABS Mastersmith

[email="[email protected]"]Email me[/email]

www.rheaknives.com

 
Posted : 30/10/2018 7:01 am
Posts: 36
Member
Topic starter
 

|quoted:

Daniel, Your photos need resizing a bit smaller please.

Whoops I apologize. I will look into how to do that right now.

 
Posted : 30/10/2018 7:09 am
Posts: 36
Member
Topic starter
 

Fixed now I believe!

 
Posted : 30/10/2018 7:35 am
Karl B. Andersen
Posts: 1067
Member
 

You got it, Daniel - thanks.

Karl B. Andersen

Journeyman Smith

 
Posted : 30/10/2018 7:36 am
BrionTomberlin
Posts: 1675
Member
 

Thank you Daniel. I am interested to see how this goes.

Brion

Brion Tomberlin

Anvil Top Custom Knives

ABS Mastersmith

 
Posted : 30/10/2018 9:18 pm
Posts: 36
Member
Topic starter
 

Made a bit of progress today. I will try and get some pictures tomorrow. Takes a while with the tools that I have By the time I lay out the holes, center punch them, and drill them, change bits, etc……

 
Posted : 30/10/2018 9:37 pm
Posts: 36
Member
Topic starter
 

I got the two tracking pivot mounts done and made good progress on the tracking arm support. I'll post pictures when the tracking arm support is done that way I don't go posting to many pictures.

 
Posted : 31/10/2018 9:16 pm
Posts: 36
Member
Topic starter
 

OK so I quickly learned that my drill press wasn’t up to drilling holes accurately enough for this grinder I’m working on fixing a lot of the issues me old GIB had and should hopefully have it running this week.

 
Posted : 10/03/2019 11:17 pm
Share: