Notifications
Clear all

Anyone Have Information On Gas Forge Anatomy

16 Posts
7 Users
0 Reactions
5,184 Views
Posts: 177
Reputable Member Journeyman Bladesmith (5yr)
Topic starter
 

|quoted:

Good! Glad you got things "better" without having to build/rebuild. I think your post should be a learning lesson to many.....just goes to show that when it comes to a propane forge, a little thought and tweaking can go a long way!

Absolutely. There's a lot of opinions and suggestions and a lot of good builds. But I saw someone say something like "7 square inches is the ideal sized port for 1 cubic ft forge"... well.. where are they getting that information? That sounds very subjective to a few factors, especially the blower pressure. If there's some design/engineering info out there that determines those numbers, I'd love to see it so I can apply the formulas to my own build.

 
Posted : 03/11/2016 2:49 pm
Page 2 / 2
Share: