Notifications
Clear all

Etching

4 Posts
3 Users
0 Reactions
1,367 Views
Posts: 0
New Member Guest
 

Hello, my question is what should I use to actually put the piece I'm etching into the ferric? I have just been using whatever was handy to dip it in (bent wire, pliers...). I once used a piece of bent copper wire and found the copper color running down the blade I was etching. I have a vertical tank i made of pvc. Thanks for any input.

 
Posted : 01/03/2013 7:53 am
Posts: 209
Estimable Member Journeyman Bladesmith (5yr)
 

Landon

I use tie wire -- like that used to tie rebar together for concrete work. This can be purchased at just about any hardware store or Lowes, menards, etc. The wire I get has something on it to keep it from rusting so I make sure that I clean the wire as well so I do not contaminate my solution.

I ususally forge out my tangs a little long and drill a hole in the end of the tang for the wire.

Brian

 
Posted : 01/03/2013 10:50 am
Steve Culver
Posts: 827
Prominent Member Master Bladesmith/ABS Instructor
 

I use tie wire -- like that used to tie rebar together for concrete work. This can be purchased at just about any hardware store or Lowes, menards, etc. The wire I get has something on it to keep it from rusting so I make sure that I clean the wire as well so I do not contaminate my solution.

Ditto

 
Posted : 01/03/2013 11:00 am
Posts: 0
New Member Guest
 

Thanks guys, I just got home too, I guess its back to town for me...

 
Posted : 01/03/2013 12:36 pm
Share: