Notifications
Clear all

Design the Build - Build the Design

2 Posts
1 Users
0 Reactions
302 Views
Posts: 186
Reputable Member Apprentice Bladesmith
Topic starter
 

I find that need to design each build.  I use knifeprint to start my designs and then refine with other image editing software.  I have posted some of my designs online and plan to post more.  Feel free to use them if they suit your purpose.

https://www.solarstorm.ca/designs

Bob Bryenton
Solar Storm Group Ltd.
Phone: (780) 953-0016
Email: [email protected]
https://www.solarstorm.ca

“The only way of finding the limits of the possible is by going beyond them into the impossible" -- Arthur C. Clarke

 
Posted : 02/07/2023 8:25 am
Posts: 186
Reputable Member Apprentice Bladesmith
Topic starter
 

Michael Samdahl to do a gut hook like that, that extends higher than the spin, I would chisel cut  and pry up the piece and flatten while forging. (Hope that made sense) then use a dremel or rotary tool to create the round hook.  Im sure there are guys that can do that with a hammer, but I am not one of them.  I would only get it close.

for something that small like the bottle opener, I used a dremel.  You could use a drill with a sanding drum on it too I suppose.

Bob Bryenton
Solar Storm Group Ltd.
Phone: (780) 953-0016
Email: [email protected]
https://www.solarstorm.ca

“The only way of finding the limits of the possible is by going beyond them into the impossible" -- Arthur C. Clarke

 
Posted : 06/07/2023 12:46 pm
Share: